Then press the buttons one after another PROGRAM, DIRand (OPRT). Uploading a program to a CNC machine from a data carrier, in this example a LAN network – step by step Of course, the whole procedure looks similar for another data carrier. We can check it by selecting DEVICE CHANGE and then EMBED ETHER If successful, the name will appear in the field O NO. So if we have O0250 then enter 0250 and press EXECUTE. And now it is important that we give this number without the letter “O” even though it is in this form in the machine’s memory. His number / name in the machine’s memory. If you succeed, the name will appear in the F NAME field as below, eventually a message will pop up. I choose to use TEST_SIEC and press EXECUTE. It will be identified after the “Number O” as shown on the graphic below. The file name does not have to be the same as current. First, enter the name of the file under which we want it to be saved. Currently read is marked with To download the program to the data carrier connected to the machine (in this case, the LAN) select F OUTPUT.Īnd now the download procedure. We are now in the machine’s memory and we have a preview of the programs there. Then press the buttons one after another PROGRAM, FOLDER and (OPRT). We switch to EDIT editing mode and enter the program menu PROG. Method on “basic” Fanuc without Manual Guide i. Downloading a program from a CNC machine to a data carrier, in this example a LAN – step by step To use the appropriate data carrier, it is necessary to set the parameter, which was mentioned HERE. To transfer some data, of course, we need data carrier – it can be a pendrive, PCMCIA card, network, etc. to the CNC machine, is also a key issue and today it will be about the transfer of programs both ways in several ways. So it’s worth to systematically download them. It is a pity if we lose good, well-run programs, in which we put a lot of work. There will always be someone who presses the buttons on the machine faster than reads and thinks. I know from experience that it is very easy to lose all programs from a machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |